To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 17957
17956  |  17958
Subject: 
Re: NQC "No reply from RCX" Help Please
Newsgroups: 
lugnet.robotics
Date: 
Mon, 20 May 2002 12:24:00 GMT
Viewed: 
2439 times
  
In lugnet.robotics, Dave Baum writes:
> In article <GwE5w8.B9t@lugnet.com>, "Jeff McClain" <jmcclain@spro.net>
> wrote:
> > Well, I'm having a similar problem, but in my case, NQC and bricxcc just
> > don't even ever see the brick.  I have firmware installed, and the Lego RIS
> > 2.0 software works and communicates perfectly with the brick (little green
> > light on the USB tower and everything...can download basic programs, etc).
> > Problem is, Bricxcc says it can't see the brick and NQC says there was an
> > error "could not open serial port".  The little green light never goes on in
> > the tower.

<snip>

> What version of NQC are you using?
> 
> As for WinXP, I don't think NQC itself should have any trouble, and if
> the RIS software is working, then I'd assume the Lego USB driver is also
> ok.

The most likely thing I can think of is some program is running that is
holding open the USB Tower port.  I think Jeff told me via e-mail that he is
using the latest release of BricxCC/NQC.  A less likely alternative would be
a misconfiguration/improper install of the USB Tower drivers that would
somehow not cause the RIS software to similarly fail.  But that seems far
fetched.

John Hansen



Message has 1 Reply:
  Re: NQC "No reply from RCX" Help Please
 
(...) I'm about to go ahead and wipe the laptop hard drive and just reinstall WinXP and see if I can get everything working from a clean install. I've done a LOT of things on this lap top and had quite a few USB devices installed... -Jeff McClain (24 years ago, 20-May-02, to lugnet.robotics)

Message is in Reply To:
  Re: NQC "No reply from RCX" Help Please
 
(...) My first guess on this problem is that the firmware is no longer loaded on the RCX. Check the LCD display - if it doesn't show 5 digits (e.g. "00.00 1") then the firmware isn't installed. If you can locate the firmware file (typically called (...) (24 years ago, 20-May-02, to lugnet.robotics)

12 Messages in This Thread:



Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR