 | | List software?
|
|
What software runs this mailing list? I ask because I'd like to find out what it would take to get it to put the ML address into messages as the Reply-To address. I run a couple of lists myself (using 7-line SED scripts) and it seems like this (...) (24 years ago, 2-Apr-01, to lugnet.robotics)
|
| |
| | Re: Racing Line Follower
|
|
I think I would take your stop watch back to the jeweler. -- Bob Fay rfay@we.mediaone.net (URL) Fasting" <lego-robotics@crynwr.com> wrote in message news:3.0.6.32.200104...line.no... (...) (24 years ago, 2-Apr-01, to lugnet.robotics)
|
| |
| | Re: Racing Line Follower
|
|
(...) HeHeHe !!! :-) (24 years ago, 2-Apr-01, to lugnet.robotics)
|
| |
| | Re: List software?
|
|
(...) No no no no no no no!!!! I ABSOLUTELY hate mailing lists that do that; it makes it near impossible to reply just to the sender. --Ken (24 years ago, 2-Apr-01, to lugnet.robotics)
|
| |
| | Re: List software?
|
|
(...) In my experience, one wants to reply to the list more often than just to the sender. Perhaps I'm wrong. In any case, anyone wishing to just reply to the sender would remove the list address from their outgoing message, and fill in the sender's (...) (24 years ago, 2-Apr-01, to lugnet.robotics)
|
| |
| | Delayed BrickBots contest results
|
|
Hi Folks, Two BrickBots.Com contests ended last week, and here is a rundown of the results. First, the Top Spinning Challenge - Get as many tops spinning simultaneously for as long as possible. (URL) Tip Top Top Tipper Score: 27 points! (URL) (...) (24 years ago, 2-Apr-01, to lugnet.robotics)
|
| |
| | Re: Racing Line Follower
|
|
In Creative Projects I make recommendations on line followers. One of them is to add a touch sensor that you can use as a trigger to grab the light levels of the line and the surface and store them in memory. Then you can use the average of those (...) (24 years ago, 2-Apr-01, to lugnet.robotics)
|
| |
| | Re: Racing Line Follower
|
|
(...) I've built a few line followers to see how fast I can do the test track - but I've concluded that you have a quality/speed tradeoff. I've built robots that *approximately* follow the track at these kinds of speeds - but without some kind of (...) (24 years ago, 2-Apr-01, to lugnet.robotics)
|
| |
| | Re: List software?
|
|
(...) Ditto. I find this *INCREDIBLY* annoying - because this is the only one of over a dozen mailing lists that I'm subscribed to that works this way. What ends up happening is that people *don't* politely edit the 'To:' lines - instead they hit (...) (24 years ago, 2-Apr-01, to lugnet.robotics)
|
| |
| | Lubricating technic turntables
|
|
Greetings, Any suggestions to safely yet effectively lubricate technic turntables? I have four which are somewhat stiff and require a fair amount of torque to rotate. Thanks in advance! Cheers, Carl Jagt (24 years ago, 3-Apr-01, to lugnet.robotics)
|
