Subject:
|
Re: Pneumatic tubing...
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Thu, 1 Feb 2001 22:07:29 GMT
|
Viewed:
|
1566 times
|
| |
|
|
In lugnet.robotics, Jonathan Brown writes:
> I know I've seen someone suggest a non-LEGO source for tubing compatible with
> LEGO pneumatics, but after half and hour of searching through past posts I • can't
> locate it (so sorry for any repitition). I have tried auto parts stores • (vacuum
> tubing -- too thick) and RC model shops (poly tubing -- a bit stiff). Does
> anyone have a good sense of
>
> * the exact material used for the LEGO pneumatic tubing (looks like it might • be
> silicone to me, but I'm not an expert)
> * dimensions for the ID, OD and wall thickness (probably metric, since it's
> LEGO).
>
> TIA
>
> JP
I don't know, I found the following on the first page of search results for
"pneumatic tubing", took all of 3 seconds:
http://news.lugnet.com/robotics/?n=4193
|
|
Message has 1 Reply:
 | | Re: Pneumatic tubing...
|
| Dear Tom (...) Thanks for your reply. You'll notice that I mentioned in my original question that the tubing available in the RC shops (which I referred to as poly tubing rather than neoprene -- my bad) is a bit stiff. I had a vague memory of (...) (26 years ago, 1-Feb-01, to lugnet.robotics)
|
Message is in Reply To:
| | Pneumatic tubing...
|
| I know I've seen someone suggest a non-LEGO source for tubing compatible with LEGO pneumatics, but after half and hour of searching through past posts I can't locate it (so sorry for any repitition). I have tried auto parts stores (vacuum tubing -- (...) (26 years ago, 1-Feb-01, to lugnet.robotics)
|
11 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
