To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *28679 (-20)
  Need help with bumpers connected to the HB
 
Hi, I’ve got a problem in getting started with the Handy Board. I’d like to connect a bumper detection circuit to the analog0 of my HB. But when I connect the bumper circuit to my HB , the HB turns itself off. Can anybody help me? Any help would be (...) (25 years ago, 23-May-01, to lugnet.robotics.handyboard)
 
  Re: High Strength Powered Steerable pivot wheel
 
(...) I'm looking forward to the old sets, my last taste of LEGO was in the 70's, and all my bricks from that time are long gone. Mindstorms have re-kindled my love of lego, and technics feed the machine. If the two technics sets are re-released, it (...) (25 years ago, 23-May-01, to lugnet.robotics)
 
  LVI install problems
 
Given that I'm new to Java this is probably a silly question, but when I try to install LVI I get the error: C:\Steve\Lego\lejos\lvi>java install Exception in thread "main" java.lang.NoClassDefFoundError: install Java2 and LeJOS seem to be working (...) (25 years ago, 23-May-01, to lugnet.robotics.rcx.java)
 
  Re: High Strength Powered Steerable pivot wheel
 
(...) All the replies were apparently trying to help you to create a steerable wheel with no motors in the assembly. Did you consider rotating the entire motor/wheel assembly? The advantage is that you don't need a drive to go through the rotating (...) (25 years ago, 23-May-01, to lugnet.robotics)
 
  Re: 27 IR signals by using the LEGO Remote Control
 
(...) 11 (...) Alternatively, input 1 could be start/stop frame and input 2 and 3 could be 0 and 1 allowing you to enter any binary number (low bit first). This is workable for us nerd couch potatoes who think in binary and are really fast with the (...) (25 years ago, 23-May-01, to lugnet.robotics)
 
  Re: 27 IR signals by using the LEGO Remote Control
 
This is a good idea. You could use the same principle to send 27 different values to a single RCX. I.e. your one and only RCX could act as its own MUX. Here's an encoding scheme that gives you 1 one-key combination, 3 two-key combinations, and 6 (...) (25 years ago, 23-May-01, to lugnet.robotics)
 
  27 IR signals by using the LEGO Remote Control
 
I've found a way to provide 27 IR signals from the LEGO remote control. See my site for an explanation: (URL) essence you need 2 RCX, 1 to act as a MUX. (25 years ago, 23-May-01, to lugnet.robotics)
 
  Re: Wishlist leJOS
 
(...) You could use the JavaComm package, look on the Java website for it. It should not be that hard to set up the port, write to it, and then get replies back. Look at the other Java projects mentioned on (URL) to see how communication is done. I (...) (25 years ago, 23-May-01, to lugnet.robotics.rcx.java)
 
  Re: Wishlist leJOS
 
I (another newbie) also would like to upload data from the RCX to a Windows PC. It looks like adding the data to a StringBuffer would be a good way to save it, but I have not much of a clue about how to write (1) the Java that runs on the PC to (...) (25 years ago, 23-May-01, to lugnet.robotics.rcx.java)
 
  Re: SHRIMP building
 
(...) Yes, something like this: | is a wheel pointed straight, \ and / are wheel turned left or right = is the body Going straight: | | |==| |==| | | Turning left: \ \ |==| |==| / / Turning right: / / |==| |==| \ \ Disclaimer: I haven't actually (...) (25 years ago, 23-May-01, to lugnet.robotics)
 
  Re: SHRIMP building was: Re: High Strength Powered Steerable pivot wheel
 
(...) Yes, something like this: | is a wheel pointed straight, \ and / are wheel turned left or right = is the body Going straight: | | |==| |==| | | Turning left: \ \ |==| |==| /==/ Turning right: / / |==| |==| \ \ Disclaimer: I haven't actually (...) (25 years ago, 23-May-01, to lugnet.robotics)
 
  Re: Will not keep P-Code.....
 
Rmoving every chips except 62256 RAM and 74HC132, and try it again if it works. Besides the memory chip (62256), please also check the 74HC373 (under-neath the 62256 RAM). Patrick Hui (URL) Original Message ----- From: "Kurt Telep" <kt25@drexel.edu> (...) (25 years ago, 22-May-01, to lugnet.robotics.handyboard)
 
  Re: RCX motor pulsing
 
(...) Yes. When you set the power for an output port actually you select the duty cycle of a square wave. The granularity depends on firwmare. With standard firmware you can select between 7 power levels; legOS has 255 levels. bye Bernardo New (...) (25 years ago, 22-May-01, to lugnet.trains, lugnet.robotics)
 
  Re: Lego Camera and legOS
 
(...) IIRC, the identifier chip is different, so it returns a different ID, otheriwse it is a regular QuickCam. Change the driver so it recognizes the different chip, and it should work (at least this is what it seemed to be on the robotics mailing (...) (25 years ago, 22-May-01, to lugnet.robotics.rcx.legos)
 
  Re: RcxCC Font problem
 
(...) That worked. Thanks a lot. (...) No problem for me. I only use my font in regular style. Marc Klein Marc Klein A Mindstorms fan. (25 years ago, 22-May-01, to lugnet.robotics.rcx.nqc)
 
  Re: Lego Camera and legOS
 
Hi, There are two versions of the Logitech QuickCam Express which use two different sensors and as far as I know, only one of them is supported by the alpha driver for Linux. I think that the Lego Cam (and your camera, maybe)uses the other sensor... (...) (25 years ago, 22-May-01, to lugnet.robotics.rcx.legos)
 
  Will not keep P-Code.....
 
Well, I recently got a hold of a handyboard from a |friend of mine who swore it was "junk and didnt' work" | After cleaning up some ugly looking solder joints on |the board, it powered right up and began to work |great. Well, when I went to screw it (...) (25 years ago, 22-May-01, to lugnet.robotics.handyboard)
 
  New Version: MacNQC 2.2.3
 
Hi All, I just put up version 2.2.3 of MacNQC. The changes are: * Added a menu to select which program slot the code is to be downloaded into. * Added command in the editor to shift text left or right on tab space. * Fixed a memory corruption (...) (25 years ago, 22-May-01, to lugnet.robotics.rcx.nqc)
 
  Re: Wishlist leJOS
 
(...) I didn't think of that, but it might explain why my attemps to use the OP cods failed (they hung the RCX completely dead). Then again, I might have used them wrong... Björn (25 years ago, 22-May-01, to lugnet.robotics.rcx.java)
 
  Re: Lego Camera and legOS
 
Last I checked, the chip which the lego camera uses is unsupported under linux. I wrote up a short discussion of what I knew at the time here: (URL) is even less than I seem to remember knowing but hopefully the link there can be helpful. Luis (...) (...) (25 years ago, 22-May-01, to lugnet.robotics.rcx.legos)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR