To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *25659 (-20)
  English version of VC software - where, from?
 
Hello. I am new to LEGO Mindstorms world. I live in Poland where LEGO is not selling its Vision Command extension to Mindstorms. I have it bought in Germany. Unfortunately the software included in a.m. set was localized, and is available only in (...) (26 years ago, 31-Dec-00, to lugnet.robotics.vc)
 
  Motor Drivers
 
Hi, Currently I'm using an L298 to drive a couple of DC motors. Unfortunately the only way I can intorduce any sort of speed control is to PWM the enable line since PWM'ing the inputs for speed control does not work. Does anyone else know of any (...) (26 years ago, 31-Dec-00, to lugnet.robotics)
 
  Re: Message transmission speeds.
 
In the RCX and the tower, the IR receiver is located close to the transmitter. When the transmitter is running, the adjacent receiver's Automatic Gain Control cirucit (AGC) becomes saturated, and sets the receiver sensitivity to it's lowest possible (...) (26 years ago, 30-Dec-00, to lugnet.robotics)
 
  (canceled)
 
 
  (canceled)
 
 
  how long can i keep the rcx on
 
Dear Group One question For how many hours can i keep the rcx connected to the mains .. and kept running ,, Can i keep it on for many hours?? Dr Patel (26 years ago, 1-Jan-01, to lugnet.robotics)
 
  Wish All of you A Very HAPPY NEW YEAR
 
Hi Group Wish All of u a Happy New Year to you .. From Dr Patel (26 years ago, 1-Jan-01, to lugnet.robotics)
 
  Re: Message transmission speeds.
 
(...) Oops. Two mistakes there. (5 + 1 + 1)*4 = 28 not 24, which is moot because "messages" apparently have a prefix of hex F7 as part of the data payload, so a message is actually 9 bytes or about 36ms. Makes it sound like you're doing nothing (...) (26 years ago, 31-Dec-00, to lugnet.robotics)
 
  Re: Message transmission speeds.
 
(...) (snip) (...) The data rate is 2400bps, and each packet of N bytes of data has 5 + N bytes of overhead. So the more realistic time to send a 1 byte message is 24ms. Here is an excerpt from the Communication section of (URL) Did you check the (...) (26 years ago, 31-Dec-00, to lugnet.robotics)
 
  Message transmission speeds.
 
I'm thinking about building a robot with three Scouts acting as slaves to a single RCX - nine motors and a dozen sensors in all! I'm not quite sure what they are all going to do yet - but I want to plan the communications mechanisms first. What I'm (...) (26 years ago, 31-Dec-00, to lugnet.robotics)
 
  Re: Best set..
 
"Ralph Hempel" <rhempel@bmts.com> wrote in message news:NEBBIJADEJHLFJD...mts.com... (...) equivalent (...) I would have to agree. I have two code pilots and would gladly buy more (if they ever go on sale). Other great sets, which are no longer (...) (26 years ago, 31-Dec-00, to lugnet.robotics)
 
  Re: Vision Command Questions
 
The camera is a good quality and is most responsive to motion. The light and color sensitivity seem to be rather marginal. The big drawback is the cable to the camera. It is 16 feet long, which is great, but it is quite stiff and a cumbersome (...) (26 years ago, 31-Dec-00, to lugnet.robotics.vc)
 
  Re: Vision Command Questions
 
(...) etc? (...) color. (...) VC only uses Hue to detect color. The color is trained by showing it to the camera. Hue varies between 0 and 359. A match must be within +/- 10 of the trained color. A big problem with detecting color with this method (...) (26 years ago, 31-Dec-00, to lugnet.robotics.vc)
 
  Re: better 9719 RIS 1.0 or 9747 RIS 1.5?
 
If you build projects that are stationary, the 1.0 is the best bet. The cost of batteries makes the power connector very valuable. -- Bob Fay California, USA rfay@we.mediaone.net (URL) (26 years ago, 31-Dec-00, to lugnet.robotics)
 
  Re: Vision Command Questions
 
(...) Yes ! It's an USB camera (logitech webcam with a lego-like cover and another harware key) (...) Yes ! (I don't know how the already written activeX control works.) (...) Color detection is not realy good for my opinion. A little difference in (...) (26 years ago, 31-Dec-00, to lugnet.robotics.vc)
 
  Vision Command Questions
 
Hello, I have a few questions about Vision Command. 1. I'm a little confused about how the camera interfaces with the RCX. Does the camera just send data to the PC and then the PC sends commands to the RCX via the infrared tower? 2. Do you have to (...) (26 years ago, 31-Dec-00, to lugnet.robotics.vc)
 
  Re: Scout Booster Set
 
(...) A printed sheet packed in the Robotics Discovery Set #9735 box with the Scout offers the follow promise: "In late 2000, LEGO MINDSTORMS will release a booster pack that will let your Scout work with your PC. The booster pack will let you (...) (26 years ago, 30-Dec-00, to lugnet.robotics.scout)
 
  Re: better 9719 RIS 1.0 or 9747 RIS 1.5?
 
(...) Depends. If you want the capability of plugging into wall power, you want a 9719 (plus, you might still be able to get a free upgrade kit even though the date has long since passed - it never hurts to call on these things). If they're at the (...) (26 years ago, 30-Dec-00, to lugnet.robotics)
 
  better 9719 RIS 1.0 or 9747 RIS 1.5?
 
If you could still get 9719 RIS 1.0 and 9747 RIS 1.5, each $200, which would you get or would you get both? (26 years ago, 30-Dec-00, to lugnet.robotics)
 
  RE: Sending commands directly in Perl
 
(...) I had the same problem with my Tcl script. You need to load the standard firmware into the RCX first. Use firmdl3 or similar software if you're using Linux... Cheers, Ralph Hempel - P.Eng ---...--- Check out pbFORTH for LEGO Mindstorms at: (...) (26 years ago, 30-Dec-00, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR