To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 13657
13656  |  13658
Subject: 
RE: Sending commands directly in Perl
Newsgroups: 
lugnet.robotics
Date: 
Sat, 30 Dec 2000 15:00:56 GMT
Viewed: 
871 times
  
Hello !
I'm a french guy, new in this mailing-list. I've bought the Mindstorm
whith my 14 years old son.
He uses the windows interface, but I prefer Linux :-)
I've searched on several sites, but I've not found the solution to my
problem ...
I use the talkrcx.pl script, and it works fine. The ping command (10 in
hex) receives the correct answer (e7).
When I use commands like Get Value (120c01 : get the raw value from
sensor 1) I receive a correct answer.
But with commands like Set Variable (14050c01 : store the raw value from
sensor 1 in variable 5) there is no answer (e3 expected).
Is there any previous command (or serial of command) to initialise the
RCX to accept my command ?
If the answer to my question is yet in a FAQ, thanks to tell me !

I had the same problem with my Tcl script. You need to load
the standard firmware into the RCX first. Use firmdl3 or similar
software if you're using Linux...

Cheers,

Ralph Hempel - P.Eng

--------------------------------------------------------------------
Check out pbFORTH for LEGO Mindstorms at:
<http://www.hempeldesigngroup.com/lego/pbForth>

Buy "Extreme Mindstorms: an Advanced Guide to Lego Mindstorms"
<http://www.amazon.com/exec/obidos/ASIN/1893115844/hempeldesigngrou>
--------------------------------------------------------------------
Reply to:      rhempel at bmts dot com
--------------------------------------------------------------------



Message is in Reply To:
  Sending commands directly in Perl
 
Hello ! I'm a french guy, new in this mailing-list. I've bought the Mindstorm whith my 14 years old son. He uses the windows interface, but I prefer Linux :-) I've searched on several sites, but I've not found the solution to my problem ... I use (...) (24 years ago, 30-Dec-00, to lugnet.robotics)

2 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR