Subject:
|
Re: Weeping Willow
|
Newsgroups:
|
lugnet.org.ca.vlc
|
Date:
|
Tue, 24 Jul 2001 04:37:25 GMT
|
Viewed:
|
1049 times
|
| |
|
|
In lugnet.org.ca.vlc, Dean Husby writes:
> Great. Here's what will need to get to and from the RCX.
> The power cord (Same as a train Power plug)
> one wire going out to the Sensor east.
> Another sensor inside the mountain (so we know when the train has cleared the
> switch)
> A motor wire going east to the switch track
> Another one going to the track it's self. (Requires isolation on both ends of
> the hogwarts area)
> and one more for the 'tree'.
Ok I think I've left enough room for all of the above. But why do we need a
(motor?) wire running to the track?
Also, I'm not quite clear as to the sensor you're talking about... Do we
have to place it inside the mountain?
Perhaps the dry-run will answer most of these questions.
-Bryan
|
|
Message has 1 Reply:
 | | Re: Weeping Willow
|
| (...) If you want the train to stop at the station you must isolate the track and run it by the MS. (...) There is one magnet sensor before the switch track. And there is a light sensor just after the switch track. (...) Yes. I have 7 more sensors (...) (23 years ago, 24-Jul-01, to lugnet.org.ca.vlc)
|
Message is in Reply To:
| | Re: Weeping Willow
|
| (...) Great. Here's what will need to get to and from the RCX. The power cord (Same as a train Power plug) one wire going out to the Sensor east. Another sensor inside the mountain (so we know when the train has cleared the switch) A motor wire (...) (23 years ago, 23-Jul-01, to lugnet.org.ca.vlc)
|
16 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
