Subject:
|
Re: Weeping Willow
|
Newsgroups:
|
lugnet.org.ca.vlc
|
Date:
|
Mon, 23 Jul 2001 16:52:16 GMT
|
Viewed:
|
903 times
|
| |
|
|
Robin Sather wrote:
> > Robin, in regards to your 'tree'. What would you like the settings to
> > be? ie, shaking, stop or wiggle or whatever it does... etc... I'm going
> > to tie it into the Switch Track RCX.
>
> First of all, it's a "Whomping Willow", and it doesn't shake or
> wiggle, it "trembles with rage and anger" at anyone who comes near!
>
> ;-)
I know... heh heh. I was being elusive. ;-)
>
> Therefore, I think that if you timed it so that when the train rolled
> in, just turn on the power to that motor for a bit, then turn it off
> again, that would be fine.
where is the tree in relation to the station? Does it activate before or
after the stop?
Dean
|
|
Message has 1 Reply:
 | | Re: Weeping Willow
|
| (...) I plan to put it behind (below) the station about 20 studs, near the mountain side. If the RCX was in that ridge, the wire would reach no problem. If you timed it to activate roughly at the time the train would be pulling in, or perhaps just (...) (23 years ago, 23-Jul-01, to lugnet.org.ca.vlc)
|
Message is in Reply To:
| | Re: Weeping Willow
|
| (...) First of all, it's a "Whomping Willow", and it doesn't shake or wiggle, it "trembles with rage and anger" at anyone who comes near! ;-) Therefore, I think that if you timed it so that when the train rolled in, just turn on the power to that (...) (23 years ago, 23-Jul-01, to lugnet.org.ca.vlc)
|
16 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
