Subject:
|
Re: Weeping Willow
|
Newsgroups:
|
lugnet.org.ca.vlc
|
Date:
|
Mon, 23 Jul 2001 21:46:25 GMT
|
Viewed:
|
1018 times
|
| |
|
|
In lugnet.org.ca.vlc, Dean Husby writes:
> Great! Where is the hole or is it completely hidden? Can you leave a little
> hole facing the middle of the layout so that I can IR it commands without
> having to remove it each time? If the hole was 6x3 that should be fine. (6
> long, 3 high) the IR cover is black.
Ok, now that we've got all our directions sorted out, I've found a new
location for the RCX. :)
It's inside the northern-most piece of mountain. The hole for IR commands
faces east, towards the rest of the layout. You can also run wire out from
that hole. I'm about to make a smaller gap, just enough to run wire, on the
western face of the mountain, so we can reach the Whooping Willow. :P
-Bryan
|
|
Message has 2 Replies:
 | | Re: Weeping Willow
|
| (...) Great. Here's what will need to get to and from the RCX. The power cord (Same as a train Power plug) one wire going out to the Sensor east. Another sensor inside the mountain (so we know when the train has cleared the switch) A motor wire (...) (23 years ago, 23-Jul-01, to lugnet.org.ca.vlc)
|
Message is in Reply To:
| | Re: Weeping Willow
|
| (...) Great! Where is the hole or is it completely hidden? Can you leave a little hole facing the middle of the layout so that I can IR it commands without having to remove it each time? If the hole was 6x3 that should be fine. (6 long, 3 high) the (...) (23 years ago, 23-Jul-01, to lugnet.org.ca.vlc)
|
16 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
