To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.org.ca.rtltorontoOpen lugnet.org.ca.rtltoronto in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Organizations / Canada / rtlToronto / 5068
5067  |  5069
Subject: 
Re: Train width clearance for wide turns, etc.
Newsgroups: 
lugnet.org.ca.rtltoronto
Date: 
Wed, 31 Jul 2002 18:19:19 GMT
Viewed: 
1457 times
  
I assume that all the bogies are 8 long and rotate at the centre?  That
is, each consists of 2 3x4 new wheelsets with a 2-stud gap between?
That's what it looked like  in the photos, anyway.

Jeff E


Derek Raycraft wrote:
> 
> Ok I figured out the size of the Go Train last night.
> 
> Passenger Cars:
> Length: 50
> 8 wide length: 48
> Bogie plate pin sits between the 6 and 7th studs from the ends.
> 38 studs between bogie plate pins.
> 
> Engine:
> Length: 45
> 8 wide length: 44
> Bogie plate pin sits between the 11 and 12th studs from the back.
> Bogie plate pin sits between the 10 and 10th studs from the front.
> 24 studs between bogie plate pins.
> 8 wide starts at the front.
> 8 wide stops one stud front the back.
> 
> The couplers are not included in these dimensions.  They don't effect
> the swing out of the cars anyway.
> 
> The passenger cars are what cut the inside of the corners the most, the
> Engine sticks out to the outside the most.
> 
> I'll try and do up a proper diagram for the wide turn soon, but for now
> you should be able to dumbie up some cars to test with.
> 
> Derek



Message has 1 Reply:
  Re: Train width clearance for wide turns, etc.
 
The passenger car bogies are 8 long with the pin in the middle. The Engine has one motor and one dumbie motor which has the same geometry as a motor. The actual size of the bogies shouldn't make a difference provided the pin is centered between the (...) (24 years ago, 31-Jul-02, to lugnet.org.ca.rtltoronto)

Message is in Reply To:
  Re: Train width clearance for wide turns, etc.
 
Ok I figured out the size of the Go Train last night. Passenger Cars: Length: 50 8 wide length: 48 Bogie plate pin sits between the 6 and 7th studs from the ends. 38 studs between bogie plate pins. Engine: Length: 45 8 wide length: 44 Bogie plate (...) (24 years ago, 31-Jul-02, to lugnet.org.ca.rtltoronto)

9 Messages in This Thread:



Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR