Subject:
|
Re: Y??? 'Cause I'm asking!!!
|
Newsgroups:
|
lugnet.org.ca.rtltoronto
|
Date:
|
Fri, 13 Jan 2006 22:44:43 GMT
|
Viewed:
|
6087 times
|
| |
|
|
Rob Antonishen wrote:
> On 1/13/06, Derek Raycraft wrote:
>
> > Rob Antonishen wrote:
> >
> > > I'd disagree. I think shared walls should be allowable (as I can't
> > > think of a good reason why not :)
> > >
> > > I'd say the XXXXOOOOOOOOXXXXOOOOOOOOXXXX is allowed so long as it is
> > > all on one plane. This (two openings) is the maximum that can fit on
> > > one straight wall les than 12" long.
> >
> > >
> >
> > > Other thoughts on this?
> >
> > Ok but this was discussed months ago and it was decided that this would
> > not be allowed. I don't think this issue should be reopened at this stage.
>
>
> I'm OK with that. I just know it never made it into the "official"
> transfer set description, or the "guidelines", so I didn't know it had
> been agreed to.
>
> -Rob A>
After reviewing the offical draft rules page, this MIGHT cover it, but
could be open to interpatation.
--snip---
The width of the outside dimension can be as wide as you want, except
that it must always preserve the 4 dot margin on each side.
----end---
And was addressed in the thread:
http://news.lugnet.com/org/ca/rtltoronto/?n=15246
Chris
|
|
Message is in Reply To:
10 Messages in This Thread:
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
