Subject:
|
Re: [rtlToronto] rtlToronto20 Draft Rules Posted
|
Newsgroups:
|
lugnet.org.ca.rtltoronto
|
Date:
|
Wed, 23 Nov 2005 04:53:39 GMT
|
Viewed:
|
1100 times
|
| |
|
|
On 22-Nov-05, at 6:10 AM, Calum Tsang wrote:
> Hi folks,
>
> The product of many long debates, rtlToronto20: Project Y's draft
> rules are now
> posted:
>
> http://peach.mie.utoronto.ca/events/lego/lego-rtl20/
Two questions about the interface.
If I want to put two interfaces beside each other, is the minimum
distance between openings 16 or 12 studs? Measured from the centre
line of the openings.
The wall surface needs to be a uniform colour, but you don't say what
colour that is. Is that open to artistic license, or are we going to
pick the colour at some point. I think it should be a darker colour,
to make the light stand out against it.
Why is the transfer opening so deep? I was expect it to be 1 stud
deep. What's the reasoning for making it 4 studs deep?
Can you explain this line in more detail, I'm not sure what you're
getting at:
"No assemblies (eg. sensors) should permanently obstruct the Wall
Surface."
Ok that's more then two questions.
Derek
|
|
Message has 1 Reply:
Message is in Reply To:
 | | [rtlToronto] rtlToronto20 Draft Rules Posted
|
| Hi folks, The product of many long debates, rtlToronto20: Project Y's draft rules are now posted: (URL) contest is slated for February of 2006 and is currently open for debate on the issues marked in red on the webpage. Start your debates. In (...) (19 years ago, 22-Nov-05, to lugnet.org.ca.rtltoronto)
|
30 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
