Subject:
|
Re: Help with construction detail
|
Newsgroups:
|
lugnet.castle
|
Date:
|
Sun, 19 Jan 2003 02:21:08 GMT
|
Viewed:
|
749 times
|
| |
|
|
In lugnet.castle, Tanya K. Burkhart writes:
> FUT ---> .castle only
>
> Hi, folks!
>
> I'm in need of some suggestions as to how to attach this helicopter rotor:
>
> http://guide.lugnet.com/set/5031
>
> to a Technic axle. The rotor is designed to fit on a pin and spin freely,
> I'd like to use it as the base for the vanes of a windmill and connect it
> mechanically to a waterwheel below, which means axles and gears.
Try this:
http://guide.lugnet.com/partsref/search.cgi?q=32124
It's a 1x5 Technic Rotor 2 Blade with 4 Studs.
Joe Meno
|
|
Message has 1 Reply:
 | | Re: Help with construction detail
|
| (...) I meant a mill-wheel. A water wheel and a windmill would be redundant, wouldn't it? (...) I have this! It might do the trick. Thank you all for the suggestions. Tanya (22 years ago, 19-Jan-03, to lugnet.castle)
|
Message is in Reply To:
| | Help with construction detail
|
| FUT ---> .castle only Hi, folks! I'm in need of some suggestions as to how to attach this helicopter rotor: (URL) a Technic axle. The rotor is designed to fit on a pin and spin freely, I'd like to use it as the base for the vanes of a windmill and (...) (22 years ago, 18-Jan-03, to lugnet.castle, lugnet.technic, lugnet.general)
|
10 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
