Subject:
|
Re: MLCAD rotation (future request)
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Mon, 14 Aug 2000 21:15:08 GMT
|
Reply-To:
|
JSPROAT@IOnospam.COM
|
Viewed:
|
2286 times
|
| |
|
|
Steve Bliss wrote:
> It would also help if there were menu commands/tool buttons to move the
> rotation point to the world origin or the local origin.
Um, me too. :-,
Cheers,
- jsproat
--
Jeremy H. Sproat <jsproat@io.com> ~~~ http://www.io.com/~jsproat/
I'm betting I'm just abnormal enough to survive!
- The Tick
|
|
Message has 1 Reply:
 | | Re: MLCAD rotation (future request)
|
| Ok, I will think on this too. Just a summary: There are four options for a single part rotation: 1 - Rotate via origin of the part 2 - Rotate via center of part 3 - rotate via world origin(0/0/0) and 4 - rotate over a user set rotation point. For (...) (24 years ago, 15-Aug-00, to lugnet.cad.mlcad)
|
Message is in Reply To:
| | Re: MLCAD rotation (future request)
|
| It would also help if there were menu commands/tool buttons to move the rotation point to the world origin or the local origin. Steve "who posted all these messages while I was on vacation?" Bliss (...) (24 years ago, 13-Aug-00, to lugnet.cad.mlcad)
|
14 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
