Subject:
|
Re: "All zeros" warning (Was: Parts Tracker Activity Page)
|
Newsgroups:
|
lugnet.cad.dev.org.ldraw
|
Date:
|
Wed, 17 Oct 2001 13:32:38 GMT
|
Viewed:
|
495 times
|
| |
|
|
In lugnet.cad.dev.org.ldraw, Paul Easter writes:
> I'm the guilty party who posted such notes on the tracker. :) I still pass a
> part with these errors. Some of my earler parts have these too.
And I want to say "Thank You!" to Paul for doing this -- Lars Hassing has
performed a similar service in the past, emailing the L3P messages to part
authors.
We[1] are in the process of incorporating L3P into the part submission
function. I expect that the submit program will have to sort through the
L3P messages, as only some of the messages would warrant turning down a
submission.
> I also make notes on studs not being oriented correctly, not something I
> "hold" parts over, unless they are inverted or mis-used. This really only
> shows up on very small rendered models with full stud detail, so it's pretty
> much a non-issue. I have the logo on my studs so I can check them easily.
Are your studs oriented the same way as the studs generated by L3P->POV-Ray?
As it is now, the warnings about stud orientation might be
counter-productive, since most authors (a) wouldn't know what you mean and
(b) wouldn't have the information needed to correct the situation.
There's also the fact that TLC occasionally turns the stud-logo the wrong
direction, but that's an entirely different discussion...
Steve
--
Steve
1) 'We' being Lars, who ported L3P-check to Linux; Jacob, who installed it
on the ldraw.org server; Dan Boger, if I manage to drag him into it; and me,
umm, chief instigator.
|
|
Message has 1 Reply:
Message is in Reply To:
8 Messages in This Thread:
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
