Subject:
|
Re: Ribbed hoses synth
|
Newsgroups:
|
lugnet.cad, lugnet.cad.dev
|
Date:
|
Wed, 22 Dec 2004 18:57:56 GMT
|
Viewed:
|
1021 times
|
| |
|
|
In lugnet.cad, Don Heyse wrote:
> In lugnet.cad, Kevin L. Clague wrote:
>
> Hey I know a spiffy little recursive algorithm that'd probably do
> a nice job of that. I used to use it in 2D to reduce the size of
> vectorized scanned image files, but it should extend nicely to 3D.
>
> You start with the end points of a curve. Then you find the farthest
> point on the curve from the straight line between the ends. Split
> the line at that point if the distance is greater than your angular
> tolerance. Recursively apply this to the two new segments.
>
> The distance is just the cross product divided by the length of the
> line segment between the end points (the area of a parallelegram
> divided by the base).
>
> If you want to get fancy, you can check for a negative dot product,
> which tells you a split point is past one of the ends of the line
> segment. Then you can use the radial distance instead of the
> perpendicular distance.
>
>
> Enjoy,
>
> Don
Maybe it is indeed the best to add some features to Lsynth, for I and many with
me don't have a clue what to do with the sourcecode and formulas, the only thing
I might be useful to is in saying what would be a good userinterface...
|
|
Message is in Reply To:
 | | Re: Ribbed hoses synth
|
| (...) Hey I know a spiffy little recursive algorithm that'd probably do a nice job of that. I used to use it in 2D to reduce the size of vectorized scanned image files, but it should extend nicely to 3D. You start with the end points of a curve. (...) (20 years ago, 19-Dec-04, to lugnet.cad, lugnet.cad.dev)
|
10 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
