Subject:
|
Re: Ribbed hoses synth
|
Newsgroups:
|
lugnet.cad, lugnet.cad.dev
|
Date:
|
Sun, 19 Dec 2004 00:15:42 GMT
|
Viewed:
|
1015 times
|
| |
|
|
In lugnet.cad, Misha van Beek wrote:
> There are quite a few problems when I try to cad ribbed hoses, first
> of all, the elements existing are not appropriate. I addapted them
> to make sure they are as big as the real ones, but I can't use
> Lsynth, since it places not the amount of parts I want, and it
> places all elements far too close to eachother (I want to be ably to
> decide myself how many there will be and what their distance from
> eachother should be). Currently, I do all hoses manually
> (description of how is in the Viper topic) here is a picture:
> <http://www.brickshelf.com/cgi-bin/gallery.cgi?i=1025606> Since this
> takes very very very very very long, I ask if anyone knows an
> alternative or has suggestions...
There are plenty of other hose generators. Mlcad, LDDP, ldglite,
and LEDIT mode for emacs all have them. And I think some of them do
support fixed length hoses.
But I think the right thing to do is adapt lsynth to do what you
want. The source is available and enhancements like these have been
discussed before, and aren't all that hard to make. If you look here
you can see my attempt to adapt lsynth to handle the fixed length
50 segment rubber hoses.
http://cvs.sourceforge.net/viewcvs.py/lsynth/lsynth/lsynth/tube.c?r1=1.1&r2=1.2
It was mostly cut and paste. What you're asking for sounds similar.
Perhaps it's time to review the old discussions and revive this topic?
I suppose it depends a bit on how far along Kevin is with the LPUB
beta development.
Enjoy,
Don
|
|
Message has 1 Reply:
 | | Re: Ribbed hoses synth
|
| (...) (URL) (...) I agree with Don. I think Kevin has stated publicly in these very threads he is very open to integrating enhancements from others as long as it is easy to do and doesn't break things or make loads more work for him. He might not (...) (20 years ago, 19-Dec-04, to lugnet.cad, lugnet.cad.dev)
|
Message is in Reply To:
| | Ribbed hoses synth
|
| There are quite a few problems when I try to cad ribbed hoses, first of all, the elements existing are not appropriate. I addapted them to make sure they are as big as the real ones, but I can't use Lsynth, since it places not the amount of parts I (...) (20 years ago, 18-Dec-04, to lugnet.cad)
|
10 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
