Subject:
|
Re: How do we handle stickers in Ldraw?
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Wed, 16 Jan 2002 05:01:09 GMT
|
Viewed:
|
625 times
|
| |
|
|
I don't know if this has been brought up before or not, but if the stickers
are separate parts, they will "float" above the piece if you use L3P, L3Lab,
or LDView and have seams turned on. Since I would expect most L3P
renderings to be done with this option enabled, it may be a significant
issue.
--Travis Cobbs (tcobbs@san.REMOVE.rr.com)
|
|
Message has 1 Reply:
 | | Re: How do we handle stickers in Ldraw?
|
| (...) Good point. As far as I know seams are modelled in L3P generated Pov files by shrinking the the size of bricks by a small value. Theoretically, even regular bricks float related to each other, but since usually we look at models from a certain (...) (23 years ago, 16-Jan-02, to lugnet.cad.dev)
|
Message is in Reply To:
| | Re: How do we handle stickers in Ldraw?
|
| (...) Unfortunately, there is no 'enough' to prevent bleed-through. It totally depends on the scale any model is rendered at. At typical scale, 2LDU is really needed to prevent bleed-through from most angles. Which is a bit thick for most stickers. (...) (23 years ago, 14-Jan-02, to lugnet.cad.dev)
|
12 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
