Subject:
|
Re: unofficial new primitive -- "Rounded Corner"
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Fri, 15 Sep 2000 14:47:22 GMT
|
Viewed:
|
1284 times
|
| |
|
|
In lugnet.cad.dev, Leonardo Zide wrote:
> "Franklin W. Cain" wrote:
> >
> > Also, what extra steps (if any) do I need to do
> > to get this accepted as an "official" primitive
> > in the next update?
>
> There's a primitives group who decides if the primitive should be
> accepted or not (it's been a while since we last discussed anything so I
> don't know if it's still active). I don't have the list of members in
> this computer so I think the best thing to do is to send it to the same
> address where you would send a new part.
Yah, that would be the thing to do: send it to partsref@home.com.
> The first thing you should do is make sure that the primitive can be
> used by several other pieces, otherwise it could just be a subpart.
I'm planning on using it in the skeleton leg, and maybe retro-fitting it
into the minifig torso.[1]
--
Steve
1) Just to make Chris Dee's life more difficult.
|
|
Message is in Reply To:
 | | Re: unofficial new primitive -- "Rounded Corner"
|
| (...) There's a primitives group who decides if the primitive should be accepted or not (it's been a while since we last discussed anything so I don't know if it's still active). I don't have the list of members in this computer so I think the best (...) (26 years ago, 15-Sep-00, to lugnet.cad.dev)
|
17 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
