CAD Development : 5200


CAD / Development / 5200	5199 \| 5201

Subject:	Re: unofficial new primitive -- "Rounded Corner"
Newsgroups:	lugnet.cad.dev
Date:	Fri, 15 Sep 2000 13:00:38 GMT
Viewed:	518 times

"Franklin W. Cain" wrote: > > Also, what extra steps (if any) do I need to do > to get this accepted as an "official" primitive > in the next update? There's a primitives group who decides if the primitive should be accepted or not (it's been a while since we last discussed anything so I don't know if it's still active). I don't have the list of members in this computer so I think the best thing to do is to send it to the same address where you would send a new part. The first thing you should do is make sure that the primitive can be used by several other pieces, otherwise it could just be a subpart. Leonardo

Message has 1 Reply:

		Re: unofficial new primitive -- "Rounded Corner"
(...) Yah, that would be the thing to do: send it to partsref@home.com. (...) I'm planning on using it in the skeleton leg, and maybe retro-fitting it into the minifig torso.[1] (24 years ago, 15-Sep-00, to lugnet.cad.dev)

Message is in Reply To:

		Re: unofficial new primitive -- "Rounded Corner"
OK, I've finished this primitive, but before I re-submit it, I need to know a couple of things... Just what do I call the DAT file? On my PC's hard drive, I'm calling it "RND-CRNR.DAT". Is that food enough? Also, what extra steps (if any) do I need (...) (24 years ago, 15-Sep-00, to lugnet.cad.dat.parts.primitives, lugnet.cad.dev)

17 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search