Subject:
|
Re: CW/CCW, vertex sequence, co-planar, convex, (115kB)
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Sun, 3 Oct 1999 15:37:34 GMT
|
Viewed:
|
1142 times
|
| |
|
|
Bram Lambrecht wrote in message <19991003.083644.5095.3.braml@juno.com>...
> "Gary Williams" <graywolf@pcpros.net> writes:
> > Also, would a STEP command reset the current INVERT state? (Granted,
> > step shouldn't be used in part files, and INVERT shouldn't be used in a
> > model file, but it could happen...)
>
> I mirror sub-parts often in my models (for hoses, wings, etc.). Would
> this require an INVERT?
> --Bram
No.
Our software will detect mirror operations and correct for them.
-Gary
|
|
Message has 1 Reply:
 | | Re: CW/CCW, vertex sequence, co-planar, convex, (115kB)
|
| (...) I've been thinking the exact opposite -- mirroring should be a valid method for turning subfiles inside-out, and the software doesn't need to do anything special to deal with it (except to notice the inversion, and pass that info on to the (...) (25 years ago, 4-Oct-99, to lugnet.cad.dev)
|
Message is in Reply To:
53 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
