 | | Re: My proposal for new element orientation
|
|
Since this was posted to .cad instead of .cad.dev, here it is again: (...) There is the word "LEGO" on the studs... we could orient pieces so that "LEGO" is right-side up when seen from the front 3/4 view (for pieces with studs up, of course) (...) (...) (26 years ago, 24-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
(...) But in POV-Ray you can always add .000...0001 to the y value of the lower surface to make it render correctly (Which makes creating simple scenes much easier). --Bram Bram Lambrecht / o o \ BramL@juno.com ---...---oooo-----(_...o---...--- WWW: (...) (26 years ago, 24-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
(...) In real life the joins between the curved surfaces are smoothed. I approximated this by drawing the cylinders, but missing out the junction lines you refer to. It is a tricky part to model accurately and has no possible use (IMHO) except (...) (26 years ago, 24-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
(...) I didn't vote yet, pending the authors responses to my comments. Chris (26 years ago, 24-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: My proposal for the orientation of new elements
|
|
(...) Correcting positioning and rotational errors can be done when/if a part renumbered. Which doesn't really happen all that often (it just seems like it). Steve (26 years ago, 24-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
(...) I can understand that -- those thin-wall parts with decoration drive me crazy, because the decoration isn't visible in the default view. (...) I thought about Electric, and I'd be OK with that. (...) I followed the naming precedent from #2625, (...) (26 years ago, 24-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
(...) I wondered about that? Is it a problem if the surfaces are the same color? I'm asking because (a) I've used mono-colored coincident surfaces before, and (b) I'm working on one now. The O in the Octan logo is round on the outside, but oval'ed (...) (26 years ago, 24-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
Steve Bliss wrote in message <36d42e85.12776501@l...et.com>... (...) You are correct. I designed it this way so people could see the pack when viewed from the front, but for actually placing it on a minifig it should be turned around, like the (...) (26 years ago, 24-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
Here are some notes on pieces I've looked at. I'll post more after I've looked at the others. I'm not claiming I've done a complete review of everything, just looked at some parts in different views, scanned the code for obvious anomolies. Steve (...) (26 years ago, 24-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
(...) Oops, sorry. Steve (26 years ago, 24-Feb-99, to lugnet.cad.dev)
|
