Subject:
|
Re: New part: Plate 6 x 6 x 2/3 Cross with Dome - 30303.dat
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Wed, 24 Nov 1999 15:10:52 GMT
|
Viewed:
|
825 times
|
| |
|
|
In lugnet.cad.dat.parts, Paul Easter wrote:
> In lugnet.cad.dat.parts, Steve Bliss writes:
> > - The two outlying stud4.dat tubes (the ones to the left and right, not laying
> > on the Z axis) need some work around the base -- they are hanging out into
> > space. Look at the part with an "upside-down" view, you'll see what I mean.
> I think I know what you mean. I wasn't sure how to deal with those two tubes.
> I guess I will replot them manually.
In this case, that's about all that can be done. The area to be plotted isn't a
clean section of a cylinder, so you can't use the sloped cylinder primitives to
fill part/most of the surface.
Steve
|
|
Message has 1 Reply:
Message is in Reply To:
22 Messages in This Thread:
  
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
