Subject:
|
Re: Lines in patterns
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Sat, 4 Jan 2003 16:58:23 GMT
|
Viewed:
|
488 times
|
| |
|
|
In lugnet.cad, Niels Karsdorp writes:
> In lugnet.cad, Lars C. Hassing writes:
> > In lugnet.cad, Niels Karsdorp writes:
> > > When making lots of parts BFC compliant I noticed
> > > that many parts have lines in the patterns.
> > > Most of these lines are surrounded by polygons.
> > > What is the use of lines in (flat) patterns?
> >
> > The lines are there to have something drawn when the polygon would
> > otherwise be too small to be rendered (at low magnification).
>
> In parts like
> 2431p02
> 2431p51
> 2431bp52
> And perhaps more parts, have lines around the pattern polygons.
> The polygons on these parts seem large enough to me that the lines
> in these cases are not required for Lars' explanation.
You'll have to ask the authors then.
I think you should delete the lines.
So, have you thought about a new META?
/Lars
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: Lines in patterns
|
| (...) In parts like 2431p02 2431p51 2431bp52 And perhaps more parts, have lines around the pattern polygons. The polygons on these parts seem large enough to me that the lines in these cases are not required for Lars' explanation. (I'll convert (...) (22 years ago, 4-Jan-03, to lugnet.cad)
|
8 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
