Subject:
|
Re: Hose spreadsheet now available
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Thu, 15 Apr 1999 02:55:39 GMT
|
Viewed:
|
939 times
|
| |
|
|
You mean in the spreadsheet itself? Yes but I still dont understand
what the control points are. Are the endpoints going to be the first parts
in the section of spherical parts, or is it going to be the more cylandrical
parts. I'm sorry but I don't know what the part #'s are right now. I think I can
figure out how to do the endpoints if I know which piece it is going to be, but
it is the control points that I don't understand. Does that help?? Then how do
I get it to change the coordinates down below?
Ryan
*********** REPLY SEPARATOR ***********
On 4/14/99, at 9:31 PM, John VanZwieten wrote:
> Did you read the readme file?
>
> In lugnet.cad, Ryan Dennett writes:
> > Ok, I will need some help, because I've never used Excel the proper way :)
> > I assume all I need to do is to enter in the x y z coordinates of the=
> > endpoints
> > and the control points, but what are these points? Then after I put them=
> > in,
> > what do I do?
> > Thanks
> > Ryan
> >
> > *********** REPLY SEPARATOR ***********
> >
> > On 4/14/99, at 3:35 PM, John VanZwieten wrote:
> >
> > > > Hey, I wasn't flaming you it's just that various people have asked
> > > > about it and I never saw responses, so I just figured..
> > > > I meant no offense.
> > > > I'm goin to the site right now :)
> > > > Ryan
> > >
> > >
> > > No offense taken. I've been procrastinating long enough.
> > >
> > > -John Van
|
|
Message has 2 Replies:
 | | Re: Hose spreadsheet now available
|
| (...) Disclaimer: I don't have Excel. So I can't use Johns toy. :-( Ryan, the control points are what you use to "bend" or "stretch" the hose. Moving the control points draws the hose along with it. The original bezier curve generator used two (...) (26 years ago, 15-Apr-99, to lugnet.cad)
| | | Re: Hose spreadsheet now available
|
| No, I mean the hsreadme.txt that was included in the zip file. I'd rather you try to make a hose based on those instructions so that I can see if more/different explaination is neccessary. -John Van SCOTT R DENNETT wrote in message (...) (26 years ago, 15-Apr-99, to lugnet.cad)
|
Message is in Reply To:
17 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
