Subject:
|
Re: Hose spreadsheet now available
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Wed, 14 Apr 1999 22:51:41 GMT
|
Viewed:
|
837 times
|
| |
|
|
Ok, I will need some help, because I've never used Excel the proper way :)
I assume all I need to do is to enter in the x y z coordinates of the endpoints
and the control points, but what are these points? Then after I put them in,
what do I do?
Thanks
Ryan
*********** REPLY SEPARATOR ***********
On 4/14/99, at 3:35 PM, John VanZwieten wrote:
> > Hey, I wasn't flaming you it's just that various people have asked
> > about it and I never saw responses, so I just figured..
> > I meant no offense.
> > I'm goin to the site right now :)
> > Ryan
>
>
> No offense taken. I've been procrastinating long enough.
>
> -John Van
|
|
Message has 1 Reply:
Message is in Reply To:
17 Messages in This Thread:
   
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
