Subject:
|
Re: Hose spreadsheet now available
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Thu, 15 Apr 1999 01:30:28 GMT
|
Viewed:
|
911 times
|
| |
|
|
Did you read the readme file?
In lugnet.cad, Ryan Dennett writes:
> Ok, I will need some help, because I've never used Excel the proper way :)
> I assume all I need to do is to enter in the x y z coordinates of the=
> endpoints
> and the control points, but what are these points? Then after I put them=
> in,
> what do I do?
> Thanks
> Ryan
>
> *********** REPLY SEPARATOR ***********
>
> On 4/14/99, at 3:35 PM, John VanZwieten wrote:
>
> > > Hey, I wasn't flaming you it's just that various people have asked
> > > about it and I never saw responses, so I just figured..
> > > I meant no offense.
> > > I'm goin to the site right now :)
> > > Ryan
> >
> >
> > No offense taken. I've been procrastinating long enough.
> >
> > -John Van
|
|
Message has 1 Reply:
 | | Re: Hose spreadsheet now available
|
| You mean in the spreadsheet itself? Yes but I still dont understand what the control points are. Are the endpoints going to be the first parts in the section of spherical parts, or is it going to be the more cylandrical parts. I'm sorry but I don't (...) (26 years ago, 15-Apr-99, to lugnet.cad)
|
Message is in Reply To:
| | Re: Hose spreadsheet now available
|
| Ok, I will need some help, because I've never used Excel the proper way :) I assume all I need to do is to enter in the x y z coordinates of the endpoints and the control points, but what are these points? Then after I put them in, what do I do? (...) (26 years ago, 14-Apr-99, to lugnet.cad)
|
17 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
