Subject:
|
Re: Problem loading LUGNET .dats into LEdit
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Mon, 5 Apr 1999 13:36:28 GMT
|
Viewed:
|
1154 times
|
| |
|
|
On Mon, 5 Apr 1999 02:15:21 GMT, lehman@javanet.com (Todd Lehman) wrote:
> In lugnet.cad, main@appstate.edu (Thomas Main) writes:
> > [...]
> > I loaded the file in LDAO editor. This time, the file didn't have any
> > blank lines or wrapped lines. The .dat file I had before did (same
> > editor)
> > [...]
> > I probably originally saved this file last year.
>
> Steve, is it possible that an older version of LDAO's editor could have
> become confused by the old line-endings that ldraw.cgi used to put out?
> If so, then that's probably the root of the problem, and it's probably all
> moot by now.
It's possible, but I think (no, strike that; let me check--it will only
take a minute). Drat! I scan'n'replace for bare CR's, but not bare LF's.
So, yes, LDAO would have a problem with .DAT files where the lines are
broken by just LF's, instead of CRLF's.
Steve
|
|
Message is in Reply To:
 | | Re: Problem loading LUGNET .dats into LEdit
|
| (...) Hmm, well, that's good news and bad news then. Good news that it works, but bad news that it's going to be probably impossible to replicate. (...) Steve, is it possible that an older version of LDAO's editor could have become confused by the (...) (26 years ago, 5-Apr-99, to lugnet.cad)
|
12 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
