Subject:
|
Re: Problem loading LUGNET .dats into LEdit
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Mon, 5 Apr 1999 02:15:21 GMT
|
Viewed:
|
1170 times
|
| |
|
|
In lugnet.cad, main@appstate.edu (Thomas Main) writes:
> [...]
> I just re-downloaded this .dat file and it loads/displays properly in
> LEdit.
Hmm, well, that's good news and bad news then. Good news that it works, but
bad news that it's going to be probably impossible to replicate.
> [...]
> I loaded the file in LDAO editor. This time, the file didn't have any
> blank lines or wrapped lines. The .dat file I had before did (same
> editor)
> [...]
> I probably originally saved this file last year.
Steve, is it possible that an older version of LDAO's editor could have
become confused by the old line-endings that ldraw.cgi used to put out?
If so, then that's probably the root of the problem, and it's probably all
moot by now.
--Todd
|
|
Message has 1 Reply:
 | | Re: Problem loading LUGNET .dats into LEdit
|
| (...) It's possible, but I think (no, strike that; let me check--it will only take a minute). Drat! I scan'n'replace for bare CR's, but not bare LF's. So, yes, LDAO would have a problem with .DAT files where the lines are broken by just LF's, (...) (26 years ago, 5-Apr-99, to lugnet.cad)
|
Message is in Reply To:
| | Re: Problem loading LUGNET .dats into LEdit
|
| (...) Oh, ok...that's just the name of the first file in my \models directory...I must not have gotten it from lugnet.cad.dat (...) I just re-downloaded this .dat file and it loads/displays properly in LEdit. (...) I loaded the file in LDAO editor. (...) (26 years ago, 4-Apr-99, to lugnet.cad)
|
12 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
