Subject:
|
Re: Overlapping polygons etc
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Tue, 12 Aug 2003 01:24:09 GMT
|
Viewed:
|
1049 times
|
| |
|
|
In lugnet.cad, Ross Crawford wrote:
> OK, using your example as a guide, I finished off the part. First cut is at
> http://www.brickshelf.com/gallery/RoscoHead/cad/30518.dat
At first glance (in L3Lab), it looks fine (in non-transparent).
> I did notice, though, that using LDview, there is a definite line where the
> studs join the cylinders. I tried rotating the studs by 22.5 degrees to match,
> but the line remained. It only becomes visible at fairly high zoom, and at
> certain angles, so I figure it's acceptable. It also looks fine in MLcad (to my
> eyes) even when transparent. Comments?
Leave the studs at 0 rotation. I didn't see the lines you mention.
Steve
|
|
Message is in Reply To:
 | | Re: Overlapping polygons etc
|
| (...) OK, using your example as a guide, I finished off the part. First cut is at (URL) did notice, though, that using LDview, there is a definite line where the studs join the cylinders. I tried rotating the studs by 22.5 degrees to match, but the (...) (21 years ago, 6-Aug-03, to lugnet.cad)
|
9 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
