 | | Re: Multiple instances of CAMERA.DAT and LOOK_AT.DAT
|
|
(...) If there were a real camera dat file that included facing information, look_at.dat would then be unnecessary, and the pairing problem would go away. --Travis (16 years ago, 5-Dec-08, to lugnet.cad)
|
| |
| | Re: Tool to reconstruct models from POV files
|
|
(...) I wasn't trying to give you a guilt trip. You asked for "potential problems", and I saw that as one of them. I apologize if I came across as implying that it was a bigger "potential problem" than it really is. --Travis (16 years ago, 5-Dec-08, to lugnet.cad)
|
| |
| | Re: Render Effects, (Was: Re: L3P Question)
|
|
(...) Did you look at my render? (URL) say there is a definite glow in the lights there. It's all a matter of reflection and refraction. (16 years ago, 5-Dec-08, to lugnet.cad)
|
| |
| | Re: Using Unofficial parts in seperate folder
|
|
(...) I see your point. However, in this case (AFAIK) he is using unofficial parts that have been uploaded to ldraw.org. These files are just as much under our "control" as the official parts. Further, if the model in question does not correspond to (...) (16 years ago, 5-Dec-08, to lugnet.cad)
|
| |
| | Re: LGEO update
|
|
(...) Philo (16 years ago, 5-Dec-08, to lugnet.cad)
|
| |
| | Re: Using Unofficial parts in seperate folder
|
|
(...) I would suggest that the "official" elements should have "official" in their descriptions, instead. "Unofficial" elements can come from any of a zillion sources impossible to oversee, but the "official" elements come from a single, (...) (16 years ago, 5-Dec-08, to lugnet.cad)
|
| |
| | Re: LGEO update
|
|
(...) And here are three renders of the same model with the following command lines: -cg45,45,0 -lg45,0,0 -lg30,120,0 -lg60,-120,0 -fg -bu -sw0.5 -q3 -lgeo -ar -o -cg45,45,0 -lg45,0,0 -lg30,120,0 -lg60,-120,0 -fg -bu -sw0.5 -q3 -lgeo -o -cg45,45,0 (...) (16 years ago, 5-Dec-08, to lugnet.cad)
|
| |
| | Re: Using Unofficial parts in seperate folder
|
|
(...) Maybe all unofficial parts should have "(Unofficial)" in their descriptions. That should remove any ambiguity. -Mike (16 years ago, 5-Dec-08, to lugnet.cad)
|
| |
| | Re: LGEO update
|
|
(...) Here are the renders in which I noticed the problems: (URL) (16 years ago, 5-Dec-08, to lugnet.cad)
|
| |
| | Using Unofficial parts in seperate folder
|
|
Hi all, Recently I started working with the unofficial part files in a folder "Unofficial" in the folder of LDraw. I added this folder to the MLCad.ini file in the section [SCAN ORDER]. Next I deleted the parts.lst file and let MLCad create a new (...) (16 years ago, 5-Dec-08, to lugnet.cad)
|
