 | | Re: Renderer Questions
|
|
(...) (URL) Two burgers anda shake please! :) (20 years ago, 1-Nov-04, to lugnet.cad, FTX)
|
| |
| | Re: Beta testers?
|
|
Kevin- When I'm rendering my design, the window that allows you to run the rendering comes up. Mine is clogged with other rendering designs (des.1, des.2, etc). Do you know how to clear it up? (20 years ago, 1-Nov-04, to lugnet.cad)
|
| |
| | Beta testers?
|
|
Hi, I've been doing a lot of work on LPub over the last few months (its about time!), and I was looking for Beta testers. So far Mike and Rosco have voluneteered. The changed to LPub are all related to building instruction image generation. Some (...) (20 years ago, 1-Nov-04, to lugnet.cad)
|
| |
| | Re: Howto on : BFC "Hold" on 47457.dat
|
|
(...) Lots of thanks for the reviews! I'll make the amends later this week and resubmit. Forward and onward! :-) Edwin (20 years ago, 1-Nov-04, to lugnet.cad)
|
| |
| | Re: Howto on : BFC "Hold" on 47457.dat
|
|
(...) This has nothing (well, almost nothing) to do with BFC, but your tube on the underside of the part should use stud4a, up to the point where the tube meets main part. (...) Chris Dee explained the basic process tracking down non-compliant (...) (20 years ago, 1-Nov-04, to lugnet.cad)
|
| |
| | Re: Howto on : BFC "Hold" on 47457.dat
|
|
(...) It's a bug in L3Lab - it assumes the top-level file is BFC by default. Since most model files will naturally be BFC-compliant, this works great for viewing models. But it doesn't work correctly for viewing part files directly. Steve (20 years ago, 1-Nov-04, to lugnet.cad)
|
| |
| | Re: 3 x 2 Wedge Plates
|
|
(...) Thanks for the direction. I really though I had done something wrong with setting up my parts lib. I'll give Peeron a try in the future as well. (20 years ago, 1-Nov-04, to lugnet.cad, FTX)
|
| |
| | Re: Howto on : BFC "Hold" on 47457.dat
|
|
(...) Hummm... aside from the apparent L3Lab bug, how DO I make 47457.dat BFC compliant? I'm sure the process is more than just flipping the image around to see if any red shows up. (20 years ago, 1-Nov-04, to lugnet.cad)
|
| |
| | Re: LDGlite and LPub
|
|
In lugnet.cad.dev, Don Heyse wrote: <snip> (...) Thanks Don, I got it working for both assembly images and part images. Kevin (20 years ago, 1-Nov-04, to lugnet.cad.dev)
|
| |
| | Re: Problem to synthesize Rubber Tread
|
|
(...) Gustavo, Try rotating the left constraint 90 degrees about the axle and resynthesize until it is fixed. Then do the same with the right constraint. Kevin (20 years ago, 1-Nov-04, to lugnet.cad)
|
