Subject:
|
Re: Howto on : BFC "Hold" on 47457.dat
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Mon, 1 Nov 2004 12:33:29 GMT
|
Viewed:
|
912 times
|
| |
|
|
In lugnet.cad, Edwin Pilobello wrote:
> Hummm... aside from the apparent L3Lab bug, how DO I make 47457.dat BFC
> compliant?
This has nothing (well, almost nothing) to do with BFC, but your tube on the
underside of the part should use stud4a, up to the point where the tube meets
main part.
> I'm sure the process is more than just flipping the image around to see if
> any red shows up.
Chris Dee explained the basic process tracking down non-compliant statements in
a lugnet message at <http://news.lugnet.com/cad/dev/?n=9369>.
The thing I would add is to run L3P -check against your part before starting the
process of BFC'ing.
Steve
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: Howto on : BFC "Hold" on 47457.dat
|
| (...) Hummm... aside from the apparent L3Lab bug, how DO I make 47457.dat BFC compliant? I'm sure the process is more than just flipping the image around to see if any red shows up. (20 years ago, 1-Nov-04, to lugnet.cad)
|
7 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
