Subject:
|
Re: Landing Gear Help
|
Newsgroups:
|
lugnet.build
|
Date:
|
Thu, 24 Jun 1999 19:21:29 GMT
|
Viewed:
|
669 times
|
| |
|
|
On Thu, 24 Jun 1999 17:41:03 GMT, "Duane Hess" <DNJHESS@ZDNETMAIL.COM>
wrote:
> Hear is the situation. I am roughly 3/4 of the way through building a rather
> large space cruiser and I need some landing gear to support it. I have a
> couple of retractable designs, but they won't work in the space I have alotted.
> The gear must retract into a 6 wide X 12 long area, where the height is two
> bricks (give or take, I haven't fully decided yet). The gear must also be able
> to support the weight of the ship, I estimate 1-2 pounds. For reference, the
> ship is about 90 studs long X 32 studs wide and 9 bricks tall.
>
> Any help would be greatly appreciated.
How much clearance should the ship have when the gear are extended?
Steve
|
|
Message has 1 Reply:
 | | Re: Landing Gear Help
|
| (...) alotted. (...) able (...) I would like to be able to stand a 1 x 8 or 1 x 12 on end (just a reference length). That would be from the attaching plate similar to below. I'm flexible just as long as it clears a 1 x 8 on end. I hope this helps. (...) (25 years ago, 24-Jun-99, to lugnet.build)
|
Message is in Reply To:
| | Landing Gear Help
|
| Hear is the situation. I am roughly 3/4 of the way through building a rather large space cruiser and I need some landing gear to support it. I have a couple of retractable designs, but they won't work in the space I have alotted. The gear must (...) (25 years ago, 24-Jun-99, to lugnet.build)
|
19 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
