 | | Need Help Designing a Train Table
|
|
I am hoping to finally move my Lego Trains on to a proper table so that the kids and I can actually enjoy them, instead of just admiring them (if you know what I mean). I currently have a 4 x 8 plywood set up on some saw horses and its just not (...) (14 years ago, 27-Apr-11, to lugnet.trains)
|
| |
| | Re: Need Help Designing a Train Table
|
|
Damon, You should first determine the purpose of your train tables and your long-range goals. Are the tables train tables only for your personal use, or do you anticipate using them as part of a club display. If the later is true then you need to (...) (14 years ago, 28-Apr-11, to lugnet.trains)
|
| |
| | Re: Need Help Designing a Train Table
|
|
(...) Clifton; Thank you for that info and the links. My table is only for personal enjoyment, will not be traveling, and I have a limited space in my garage. I had considered leaving a space in the middle, but your modular idea is really great. (...) (14 years ago, 30-Apr-11, to lugnet.trains)
|
| |
| | Re: Need Help Designing a Train Table
|
|
(...) Clifton; (...) We use two- inch spring clamps to connect the tables on the underside. Two per side on each side where two tables are joined: (URL) spring clamps hold the table together without damaging the wood. Our tables’ legs are attached (...) (14 years ago, 2-May-11, to lugnet.trains)
|
| |
| | Re: Need Help Designing a Train Table
|
|
(...) Rather than the custom-built-wooden-tables route, we ((URL) TCLTC>) took the folding table route, specifically (URL) THESE> from Costco (They are cheaper to purchase at the store itself). The nice thing about this table is that it can adjust (...) (14 years ago, 2-May-11, to lugnet.trains, FTX)
|
| |
| | Re: Need Help Designing a Train Table
|
|
(...) I think John raises a good point. I have a number of tables that match the wood tables my club built (they were built at the same time as the first batch) and they're sturdy and reconfigurable, but the folding tables are very attractive. They (...) (14 years ago, 4-May-11, to lugnet.trains, FTX)
|
| |
| | Re: Need Help Designing a Train Table
|
|
(...) I read your post and was trying to figure out how your tables were connected to the other club tables at NMRA (2006), but I realized after checking the photos from the event, your tables were part of the stand-alone display. Buying the COSTCO (...) (14 years ago, 11-May-11, to lugnet.trains, FTX)
|
| |
| | Re: Need Help Designing a Train Table
|
|
(...) COLTC has folding tables. For the most part they are great. They do offer a lot of flexibility for setup and arrangement. Ours fit 3x6 standard baseplates, with a half inch overhang that has never been a problem for the train tracks. We even (...) (14 years ago, 12-May-11, to lugnet.trains, FTX)
|
