To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 20883
20882  |  20884
Subject: 
Re: Combines and loads (was Re: New poster by Larry Pieniazek/MTW
Newsgroups: 
lugnet.trains
Date: 
Sat, 16 Aug 2003 22:29:15 GMT
Viewed: 
1928 times
  
In lugnet.trains, Larry Pieniazek wrote:
In lugnet.trains, Reinhard "Ben" Beneke wrote:

Ok, from the 1024x768 poster I was not too sure about it: I just saw the 6-wide
cabin and the 2 studs mudgear on each side of it.

A bit of trickery there... :-) The cab is 6 wide at the top (the hinged part)
but the stationary part is only 5 wide, using tiles to handle the mismatch. The
stationary part sits on a 6 wide plate base which is offset 1/2 stud from the
frame, and sticks out one stud only on one side.

THAT side takes the step unit, which is removed in shipment mode, but it means
the whole cab (as long as the lights are folded in for shipment too) is only 6.5
wide  (and that .5 is skewed so it's only on one side) without the step
(mudguard is what you thought it is).

Can' wait to see some more detailed pictures of this model. Sounds by far more
complicated as it seemed to be on the first view....

Ben



Message is in Reply To:
  Re: Combines and loads (was Re: New poster by Larry Pieniazek/MTW
 
(...) A bit of trickery there... :-) The cab is 6 wide at the top (the hinged part) but the stationary part is only 5 wide, using tiles to handle the mismatch. The stationary part sits on a 6 wide plate base which is offset 1/2 stud from the frame, (...) (21 years ago, 16-Aug-03, to lugnet.trains)

16 Messages in This Thread:





Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR