To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 19535
19534  |  19536
Subject: 
Re: Narrow Gauge Steam Critter in Dark Blue
Newsgroups: 
lugnet.trains
Date: 
Tue, 18 Mar 2003 23:31:24 GMT
Viewed: 
826 times
  
In lugnet.trains, Jason J. Railton writes:
In lugnet.trains, John Gerlach writes:
In lugnet.trains, Jason J. Railton writes:
In lugnet.trains, John Gerlach writes:
One question though, can you use the narrow rail spacing around corners?
For some reason I think it should work, but I haven't had a chance to try • it
yet.

I don't have any curves, but it wouldn't work exactly right.  If you think
of a 90° corner that goes up and turns right to form an 'r'.  Move the inner
rail two studs to the left.  Now, of course, it's two studs too short on the
exit at the top.  Move it two studs up, too, and again you're short.

I've thought of that problem, too.  I *think* it could be solved by building
a figure-8 track.  The outter tracks on each curve would be longer than the
inner tracks, but by having them opposite they would cancel each other out.

OK, time to dig out the 4.5volt track!!

That wouldn't work on its own.  Firstly you'd need a bridge, since a regular
crossing wouldn't be any use.  Secondly, there's no way you could keep the
tracks 2 studs apart around a 270° arc without lengthening the inner rail
somewhere.  Even a 90° arc needs the spacing to be spread out or it would
pinch too much at the apex.

Not to mention the relative radii of the short & long rails would be wrong, so
you'd end up with the rails wider apart at each joint than in the middle. This
may not be enough to make it unusable, however, depending what wheels you use
8?)

ROSCO



Message is in Reply To:
  Re: Narrow Gauge Steam Critter in Dark Blue
 
(...) That wouldn't work on its own. Firstly you'd need a bridge, since a regular crossing wouldn't be any use. Secondly, there's no way you could keep the tracks 2 studs apart around a 270° arc without lengthening the inner rail somewhere. Even a (...) (22 years ago, 18-Mar-03, to lugnet.trains)

14 Messages in This Thread:





Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR