 | | Connecting 12V Transformer to Track —John Eric Voltin
|
| | | Over the past few years, I have acquired a reasonable collection of 12V train parts including a transformer, several motors, and quite a bit of track. Unfortunately, I have not had an opportunity to see any 12V trains up close. As a result, I have (...) (23 years ago, 6-Dec-01, to lugnet.trains)
|
| | | |
| | | | | Re: Connecting 12V Transformer to Track —Jon D. Hayward
|
| | | | | The connector rail is still available direct from LEGO here in the UK, and no doubt from other countries too. Hopefully this link is valid: (URL) price here is 5.19GBP (~7.35USD) plus s&h. The set number is 5063 if you want to try searching for it (...) (23 years ago, 6-Dec-01, to lugnet.trains)
|
| | | | | |
| | | | | Re: Connecting 12V Transformer to Track —Reinhard "Ben" Beneke
|
| | | | | (...) There are 3 ways to connect the track with the transformer. - in the blue era (1969 - 1979) there was a special cable with an 2x4 plate that fitted under the electric midle track part. (URL) in the beginning of the the grey era the transfomer (...) (23 years ago, 6-Dec-01, to lugnet.trains)
|
| | | | | |
| | | | | | | Re: Connecting 12V Transformer to Track —Frank Filz
|
| | | | | | (...) I think my 7735 came with conductors with the pin holes, but it did come with a special curved conductor piece with an extra block on the bottom very much like the 5063 power supply rail. Perhaps there was an intermediate stage. I do know that (...) (23 years ago, 6-Dec-01, to lugnet.trains)
|
| | | | | | |
| | | | | | | | Re: Connecting 12V Transformer to Track —Reinhard "Ben" Beneke
|
| | | | | | (...) appears (...) No does NOT work. The grey track is different with the double amount of ties (sleepers). Kind Regards, Ben (23 years ago, 6-Dec-01, to lugnet.trains)
|
| | | | | | |
| | | | | | | | Re: Connecting 12V Transformer to Track —Frank Filz
|
| | | | | | (...) I just fiddled with it. What actually prevents it from working is not the center tie, but the tubes on the bottom of the grey conductors without pin holes, or the tubes and pin holes on those grey conductors with pin holes. Why is this so, (...) (23 years ago, 7-Dec-01, to lugnet.trains)
|
| | | | | | |
| | | | | Re: Connecting 12V Transformer to Track —John Eric Voltin
|
| | | | I appreciate the input provided by Jon, Ben, and Frank. All of their input has been helpful. After reading their responses and reviewing the older LEGO literature and brochures I have, I have learned about several different approaches. I would like (...) (23 years ago, 6-Dec-01, to lugnet.trains)
|
| | | | |
