Subject:
|
Re: check out my Water Tower model
|
Newsgroups:
|
lugnet.cad, lugnet.trains
|
Date:
|
Fri, 14 May 1999 21:12:49 GMT
|
Viewed:
|
139 times
|
| |
|
|
On Fri, 14 May 1999 20:14:59 GMT, "Ben Gatrelle"
<ben.gatrelle@nospam-bigfoot.com> wrote:
> I have created a Water Tower model and posted the DAT file in
> lugnet.dat.models but if you want to see a POV-Ray rendering check out my web
> site at:
> <http://home.att.net/~bgatrelle/creations.htm>
>
> The lower round body should really use part number
>
> The top uses the 1/4 saucer section #30117 by Steve Bliss from
> <http://www.lugnet.com/news/display.cgi?lugnet.cad.dat:213>
>
> The lower part of the tower should really use #30201, but I don't have that in
> LDRAW. I just turned the #30117 upside down. It doesn't line up exactly, but
> you get the idea.
>
> This is the first model I have posted to the CAD group and would appreciate
> any feedback.
>
> ben.gatrelle@bigfoot.com
The rendering looks cool. Add some engines to it, and it could fly. :-)
Your posting to cad.dat.models is messed up though. Several lines have been
wrapped, which causes ldlite to choke.
You can fix this by increasing the line length in the program you are using to
post from. The "standard" line length is 79 characters, which is fine for
general posting, but for posting dat files you should increase that
*temporarily* to a large number. Like 150 or so.
I also believe you can circumvent this problem by posting the dat file directly
from the web interface rather than using a newsreader or email program.
If you decide to repost the model, remember that you can also Cancel the
current post to get rid of it.
-- Terry K --
|
|
Message has 2 Replies:
 | | Re: check out my Water Tower model
|
| (...) Ben, please, if you do repost it, don't inline the parts on an MOC unless it's extremely urgent or you have no other possible place to post the model. IMHO, wait until the parts are available as part of an official LDraw release or point to (...) (26 years ago, 15-May-99, to lugnet.cad, lugnet.trains)
|
Message is in Reply To:
| | check out my Water Tower model
|
| I have created a Water Tower model and posted the DAT file in lugnet.dat.models but if you want to see a POV-Ray rendering check out my web site at: (URL) The lower round body should really use part number The top uses the 1/4 saucer section #30117 (...) (26 years ago, 14-May-99, to lugnet.cad, lugnet.trains)
|
21 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
