To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 1221
1220  |  1222
Subject: 
Re: New Freestyle Train Cars and Truck
Newsgroups: 
lugnet.trains
Date: 
Fri, 14 May 1999 21:15:03 GMT
Viewed: 
1454 times
  
On Fri, 14 May 1999 16:59:54 GMT, "James Mathis" <jmathis@arctic.nmt.edu>
wrote:

On another fender:
I wish that the standard "car fender" piece, which is 4 studs wide, were split
into halves.  With the piece split, offering individual fenders per wheel, one
could use the standard fender piece for 6 stud wide vehicles.

I wish the "airplane nose slopes" and hinged fuselage roof pieces were split
into two halves, as well, for the same reason as the fenders.  I think the
pieces would have many more potential uses if they were split in two.  Would
need a new special slope piece to fill in the gap for greater than 4 stud
applications, though.

I think that about a lot of pieces.  Like pirate boat hulls, and the
various boat hull bricks and plates.

Steve



Message is in Reply To:
  Re: New Freestyle Train Cars and Truck
 
(...) Concerning the fenders on the Fritz-Homann delivery truck: I must acknowledge that I've seen these hinge pieces used for fenders by others. From memory, I recall Eric Brok and Bram Lambrecht (spelling?) uses the 1x5 stud 1 plate think hinges (...) (26 years ago, 14-May-99, to lugnet.trains)

5 Messages in This Thread:


Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR