To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 10340
10339  |  10341
Subject: 
Re: Tank Car Mania Continues
Newsgroups: 
lugnet.trains
Date: 
Fri, 16 Mar 2001 05:54:01 GMT
Viewed: 
573 times
  
In lugnet.trains, Rich Thompson writes:
I finally managed to finish the detail on my two versions of the tank car.

<snip>

LMKWYT, as usual.

Nice work. If you like that sort of thing (8 wide... :-) ) or even if you don't!

Thanks for sharing these. Tell us about the sanding! Did you consider using
Brasso like everyone else seems to? Do you think you took much actual
material off, or just the printing?

++Lar



Message has 4 Replies:
  Re: Tank Car Mania Continues
 
Well, I have 64 of the white panels now (and I still have about 20 of the R2D2s & C3P0s after giving some to my daughters class). Brasso and Toothpaste and Goof-Off all took too long and left me with a headache. The hand sander with a light grit did (...) (24 years ago, 16-Mar-01, to lugnet.trains)
  Re: Tank Car Mania Continues
 
In lugnet.trains, Larry Pieniazek writes: . (...) I've had success using "white rouge" buffing compound from your local Sears or hardware store. That and a small buffing wheel on a bench grinder leaves a smooth finish. The Sears white compound is (...) (24 years ago, 16-Mar-01, to lugnet.trains)
  Re: Tank Car Mania Continues
 
(...) Hello, I just thought I would add my 2 cents here. I use to use Brasso without pre-sanding and as a lot of people noted that takes an incredibly long time and is hard on the fingers and the sinuses. Then I went to 600 grit sandpaper which (...) (24 years ago, 16-Mar-01, to lugnet.trains)
  Re: Tank Car Mania Continues
 
(...) As opposed to 6 wide ? Hmmm... a tank car in brown... brown cylinder halves from 6617, brown train wagon ends from 7104... where else have brown parts been popping up lately ? Ray (24 years ago, 16-Mar-01, to lugnet.trains)

Message is in Reply To:
  Tank Car Mania Continues
 
I finally managed to finish the detail on my two versions of the tank car. The first version is a standard grey tank car using 7106 Droid Escape Pod parts. The grey car is three "pod segements" long. The second car uses the same set but the white (...) (24 years ago, 16-Mar-01, to lugnet.trains)

13 Messages in This Thread:





Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR