 | | Re: Reverse Loop using mindstorms
|
|
Sorry about that message. I just wanted to see the layout, and accidently pressed "post". -Shiri (25 years ago, 26-Nov-99, to lugnet.trains)
|
| |
| | Re: Reverse Loop using mindstorms
|
|
(...) (25 years ago, 26-Nov-99, to lugnet.trains)
|
| |
| | Reverse Loop using mindstorms
|
|
Hi All, Building away last night on a new train creation and something occured to me. Has anyone used mindstorms to control a dual reverse loop circuit? You would need to block three sections of track (for two reverse loops). Sensors could detect (...) (25 years ago, 26-Nov-99, to lugnet.trains)
|
| |
| | Re: Building Bridges
|
|
Hi, all: I'm in the midst of a large bridge project myself. I'm adhering to the 2 plate slope / 1 plate rate-of-change guideline, but for other reasons. I'd add that you probably shouldn't climb sharply through turns - that just complicates the (...) (25 years ago, 26-Nov-99, to lugnet.trains)
|
| |
| | Re: Cannot access the LEGO trains web page
|
|
(...) But that e-mail address is only for the web club. They won't answer such "trivial" questions... (...) I can. It give some a flash/shockwave movie thingie. Maybe your browser doesn't have that. It's not so cool anyway... Good look, Shiri (25 years ago, 26-Nov-99, to lugnet.trains, lugnet.general)
|
| |
| | Re: Building Bridges
|
|
The two plates per track length rule is best, however my kids and I have built (and kept) a pier set that changes one block (3 plates) per track section ... it requires a heavy loco or a fairly short train, but it does allow for a shorter bridge (...) (25 years ago, 26-Nov-99, to lugnet.trains)
|
| |
| | Re: Building Bridges
|
|
Duh. I mean 2 plates not 2 studs, and 1 plate, not one stud. A stud is a measure of horizontal distance, not vertical (although technically they are convertable, no one ever speaks that way... OK, 2/5 of a stud and 4/5 of a stud for 1 plate and 2 (...) (25 years ago, 26-Nov-99, to lugnet.trains)
|
| |
| | Re: Building Bridges
|
|
Consensus seems to be: - don't change elevation by more than 2 studs per track length - this avoids overtaxing the ability of the motors to climb - don't change the rate of change in elevation by more than 1 stud per track length - this avoids (...) (25 years ago, 26-Nov-99, to lugnet.trains)
|
| |
| | Building Bridges
|
|
I'm contemplating building a bridge so my train can cross over the track below. Are there any guidelines for this. My main worry is track gradient right now. Scott A (25 years ago, 26-Nov-99, to lugnet.trains)
|
| |
| | Re: ??? with 4560
|
|
(...) Technic 1x1 bricks and black pins. James (25 years ago, 26-Nov-99, to lugnet.trains, lugnet.cad)
|
