To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.technicOpen lugnet.technic in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Technic / 809
    removing a spring from the pneumatic pump —Jeff Canar
   I just purchased a technic sub with the large pneumatic pump. I was wondering if there is an easy way to remove the spring from the pump. I've seen pictures of motorized compressors with the spring off the pump, but don't see how you get it off (...) (25 years ago, 15-Jan-00, to lugnet.technic)
   
        Re: removing a spring from the pneumatic pump —Robert G. Fay
     You can work the spring off the top of the plunger by pulling on it and unscrewing it over the knob on the plunger. It will distort the spring slightly, but it can be reinstalled in a reverse manner and still work well. -- Bob Fay (...) (25 years ago, 15-Jan-00, to lugnet.technic)
    
         Re: removing a spring from the pneumatic pump —Philip Ogston
     (...) You can also do the same off the side of the shaft - a variation of Mr. Fay's technique which causes a bit less distortion. It's hard to describe, but if you get a thumbnail under the very end of the spring-wire, you can pull the end around (...) (25 years ago, 18-Jan-00, to lugnet.technic)
    
         Re: removing a spring from the pneumatic pump —Robert G. Fay
     Good idea, Phil. Definitely a less destructive way to do it. -- Bob Fay rfay@we.mediaone.net The Shop (URL) Ogston" <ogstonpj@worldnet.att.net> wrote in message news:FoI82r.I95@lugnet.com... (...) well. (...) Fay's (...) if (...) the end (...) have (...) (25 years ago, 18-Jan-00, to lugnet.technic)
   
        Re: removing a spring from the pneumatic pump —Peter Vogel
   Note that most of the motorized compressors I've seen on the web do not use the large pump that comes with the explorer sub, they use the smaller things. Somewhere there is a web site that describes using an RCX to measure the efficiency of 3 (...) (25 years ago, 17-Jan-00, to lugnet.technic)
   
        Re: removing a spring from the pneumatic pump —Soh Chio Siong
   (...) It's here (URL) C S Soh (URL) where air is power (25 years ago, 5-Feb-00, to lugnet.technic)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR