| |
<SNIP>
troubleshooting time on this assembly.
>
> I'll update the instructions and call the project finished. :)
>
> thanks,
>
> James
Will you be posting a new .mpd file to your brickshelf account showing the
changes? BTW the othe .mpd file was *not* right. What I mean by that is
that usually when one creates a .mpd file the final/completed model is
suppose to be at the top of the .mpd file so when you open the file you see
the complete model.
Keep up the good work, I'm like this design best for its simplicity and
small use of parts as oppose to other designs I have seen.
-AHui
www.ozbricks.com/jediagh/
|
|
Message has 1 Reply:
 | | Re: Motorized Switch
|
| (...) Yes, I'll update it tomorrow; I don't have MLCAD installed at home. Sorry about the poor .mpd; this is not just my first motorized switch, it's my first time using MCLAD. :) (...) Thanks! I owe a lot to other people who have done these in the (...) (22 years ago, 7-Jun-02, to lugnet.trains, lugnet.technic)
|
Message is in Reply To:
| | Re: Motorized Switch
|
| (...) Well, some good, some bad. The good is that leaving the motor going in one direction for 20 minutes causes no separations and no apparent stress to any parts. The bad is that it did overheat the motor, which wouldn't run again until it cooled (...) (22 years ago, 7-Jun-02, to lugnet.trains, lugnet.technic)
|
16 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
