Subject:
|
Re: Technic "Ball and Axle" part question.
|
Newsgroups:
|
lugnet.general, lugnet.technic
|
Date:
|
Sat, 5 May 2001 18:42:30 GMT
|
Viewed:
|
191 times
|
| |
|
|
"Thomas Avery" <tanyatj@texas.net> writes:
> Check out set numbers 8500, 8503, & 8505 (or any of the sets in the
> Throwbot/Slizer section) on the Lugnet set reference. Many of the
> sets contain the part in question. Look at the ankle joint of the
> 2-legged Throwbot/Slizer-whatever-they-are.
No, the Slizers don't have the ball joint thing, only various joint
with ball connections. This thread was about the single ball joint
element with an axle hole.
The black ball joint with axle hole is, as far as I know, only
available in the C3PO, Stormtrooper, as well as a few of the Bionicle
sets, e.g.: 8531 Pohatu, which has two of them.
Fredrik
|
|
Message has 1 Reply:
 | | Re: Technic "Ball and Axle" part question.
|
| (...) Thanks Fredrik, I am glad to hear the “Ball/w axle-hole” part comes in smaller sets especially since those sets are from the Bionicle series. I like the simplicity of these compared to the throwbots, I just hope they will be cheaper than the (...) (24 years ago, 5-May-01, to lugnet.general, lugnet.technic)
|
Message is in Reply To:
| | Re: Technic "Ball and Axle" part question.
|
| (...) Check out set numbers 8500, 8503, & 8505 (or any of the sets in the Throwbot/Slizer section) on the Lugnet set reference. Many of the sets contain the part in question. Look at the ankle joint of the 2-legged Throwbot/Slizer-what...-they-are. (...) (24 years ago, 5-May-01, to lugnet.general, lugnet.technic)
|
16 Messages in This Thread:
 
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
