 | | Re: bushing (bush) question
|
|
(...) Note also that Type 1 & 2 are also slightly wider than a smooth 1/2 bush - about half the thickness of a tooth wider. Two of them butted together (tooth side) is exactly the same width as 2 smooths (or a single full bush). And as TJ says, (...) (23 years ago, 24-Aug-01, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: what sets include the #4 angle connector?
|
|
"Jonathan Wilson" <jonwil@tpgi.com.au> wrote in message news:3B85B100.B51E0D....com.au... (...) 8466 has a lot of them, somewhere between 10 and 20, but I didn't count them. Huw (23 years ago, 24-Aug-01, to lugnet.technic)
|
| |
| | Re: Ball & socket joints.
|
|
(...) Unfortunatlly there are only 4 ball & socket joints in the Storm trooper. neck, left and right shoulder and left elbow. I chose wrong the first time I picked. I'll have to check out Pohatu. Doh, I bought a C-3P0 and a Kopaka last night (needed (...) (23 years ago, 24-Aug-01, to lugnet.technic, lugnet.build.mecha)
|
| |
| | Re: Onward to le-koro
|
|
Well, I switched over to Netscape and the flute worked. It was well worth the trouble. John (...) (23 years ago, 23-Aug-01, to lugnet.technic.bionicle)
|
| |
| | Re: bushing (bush) question
|
|
In lugnet.robotics, Bram Lambrecht writes: [...] (...) I think this is correct. I once built the "Aliens" type walker, (URL) . I used Type 2 originally and found that after the thing would walk a few meters one of the legs would pop off. Didn't have (...) (23 years ago, 24-Aug-01, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: what sets include the #4 angle connector?
|
|
I've often wondered why TLC is so stingy with these parts. Seems to me they are extremely useful. Any ideas? as evah, John C. (...) (23 years ago, 24-Aug-01, to lugnet.technic)
|
| |
| | Re: what sets include the #4 angle connector?
|
|
(...) You can always check peeron.com: (URL) David (23 years ago, 24-Aug-01, to lugnet.technic)
|
| |
| | RE: bushing (bush) question
|
|
(...) Type 2 is newer, probably because the Type 1's were too hard to take off the axle. I've noticed that most of my loose Type 1's have a hairline fracture on one side. (...) All the parts with teeth were essentially replaced with functional (...) (23 years ago, 24-Aug-01, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: LEGO in Washington Post
|
|
snip sigh (...) Sigh... (...) SIGH... the anticipation level is rising... -Geordan- (23 years ago, 24-Aug-01, to lugnet.technic.bionicle, lugnet.build.mecha)
|
| |
| | what sets include the #4 angle connector?
|
|
All I know of are the 2 red ones in the 8448 super street sensation. Are there any other sets that contain this part? What other colors does this part come in? (23 years ago, 24-Aug-01, to lugnet.technic)
|
