|
|
 | | Re: 120 degree connector
|
| (...) Ahh, yes! That's _exactly_ what I was saying!!! Thanks for drawing this up! (25 years ago, 13-Jun-01, to lugnet.technic)
| | | | | Re: LEGO Legends
|
| BULK BEAMS! *that* would be legendary... Build On! John Matthews Duq <Duq@nlgateway.net> wrote in message news:GEor10.3Dq@lugnet.com... (...) (25 years ago, 13-Jun-01, to lugnet.technic)
| | | | | RE: 120 degree connector
|
| (...) Here's another way to construct an equilateral triangle where you attach to the sides (120 degrees apart) (URL) can of course use hinge plates instead. If you attach technic plates, you could then attach technic beam holes to the technic plate (...) (25 years ago, 13-Jun-01, to lugnet.technic)
| | | | | Re: LEGO Legends
|
| (...) Well, yeah. That's sort of the thing with the Legends idea. Without refering back to Brad's post, he mentioned that a Legends set would be the first in a line or an early outstanding example. This is a problem with Technic, because the (...) (25 years ago, 13-Jun-01, to lugnet.technic)
| | | | | Re: 120 degree connector
|
| (...) Yep, perfect sense. Try it again: (URL) J. (25 years ago, 13-Jun-01, to lugnet.technic)
| | | | | Re: 120 degree connector
|
| (...) By using 3 of the 24-tooth gears set up into a triangle, you can set the angles at whatever multiple of 15 degrees you want. If you use the older gears, you get a direct connect to 4 peg-holes aligned for standard Technic building on one side (...) (25 years ago, 13-Jun-01, to lugnet.technic)
| | | | | Re: 120 degree connector
|
| (...) Couldn't you use an equilateral triangle to construct a 120-degree angle? Like the top picture that Thomas posted, but either Technic beam extends two holes past the point where the two beams pivot. Then a simple 3-hole 1/2-wide connector (...) (25 years ago, 13-Jun-01, to lugnet.technic)
| | | | | Re: The Next Event
|
| (...) Early estimates set the next event at 19:00 GMT on 15th July 2001, but we have learnt that there is human intervention behind the scenes to 'enable' the new stuff, so an amount of variation is expected. Regards, Phil in Yorkshire. (25 years ago, 13-Jun-01, to lugnet.technic.bionicle)
| | | | | Re: 120 degree connector
|
| (...) Hi Rob, It's going to be hard to connect beams at exactly 120 degrees. There aren't many pieces that have connections at that angle. I think the 3-arm rotors will work, as you suggested. The following link contains two quick ideas that I put (...) (25 years ago, 13-Jun-01, to lugnet.technic)
| | | | | Re: 120 degree connector
|
| (...) If you can't use the three spoked plate, I would go for one of the wheels. How about the small pulley? It is probably the smallest circular part you can find with six holes, with a 3 unit diameter and 1/2 unit thickness. Fredrik (25 years ago, 13-Jun-01, to lugnet.technic)
|
|
