Subject:
|
Re: See X-Wing Fighter in Ldraw/Ldlite
|
Newsgroups:
|
lugnet.starwars
|
Date:
|
Mon, 11 Jan 1999 19:04:53 GMT
|
Viewed:
|
1108 times
|
| |
|
|
On Sat, 9 Jan 1999 07:29:20 GMT, "James Brown"
<galliard@shades-of-night.com> wrote:
> Assuming they are the same pieces (no reason for them not to be) that are in
> the '99 Adventurer's sets, then they are 1x2 bricks with a horizontal side rod,
> as previously seen only on 1x2 plates. There is a similar 1x2 brick with a
> verticle clip.
I don't think so. At least, not exactly.
In the snowspeeder, the brick attaching to the canopy looks like it is a
1x2 brick. The 1x side goes to the canopy clip. So whatever special
hardware is there, it has to go on the short-side of 1x2 brick.
If the 'clip' on the canopy is actually a short bar between two discs,
then the brick that attaches to canopy could be a 1x2 brick with a 'top
clip'[1] on the short side.
I don't know of a picture with a good view of the canopy on the X-wing
and Y-wing models.
Steve
[1] Like the clip from the 1x1 tile with top clip.
|
|
Message is in Reply To:
 | | Re: See X-Wing Fighter in Ldraw/Ldlite
|
| (...) Assuming they are the same pieces (no reason for them not to be) that are in the '99 Adventurer's sets, then they are 1x2 bricks with a horizontal side rod, as previously seen only on 1x2 plates. There is a similar 1x2 brick with a verticle (...) (26 years ago, 9-Jan-99, to lugnet.starwars)
|
11 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
