pbFORTH : 473


Robotics / RCX / pbFORTH / 473	472 \| 474

Subject:	RE: Turning the RCX off and on again (was: New pbForth 2.1.0 (and firmware speed))
Newsgroups:	lugnet.robotics.rcx.pbforth, lugnet.robotics.rcx
Date:	Thu, 11 Apr 2002 13:20:56 GMT
Reply-To:	<rhempel@bmts.com!IHateSpam!>
Viewed:	2813 times

I need to look at some items for Joerg, but I'll also look at a small supervisor that integrates the View,Run,Prgm,and On/Off buttons. This hsould be pretty easy and would be a good bit of example code. Cheers, Ralph

Message has 1 Reply:

		Re: Turning the RCX off and on again (was: New pbForth 2.1.0 (and firmware speed))
For the Workshop3D Event I use the following construct, the button handling is from the book "Extreme Mindstorms": : main ( -- ) \ Main Task init \ do main initialize ( ... ) BEGIN ( ... ) BUTTON_SCAN BUTTON_RUN? IF ( ... ) \ Calibrating BEGIN ( ... (...) (23 years ago, 11-Apr-02, to lugnet.robotics.rcx.pbforth, lugnet.robotics.rcx)

Message is in Reply To:

		Re: Turning the RCX off and on again (was: New pbForth 2.1.0 (and firmware speed))
(...) off (...) True. But I find not very practical to be forced to use the terminal to switch off the RCX or start the program again, expecially when you are attending a contest or take your robot to an exhibit. What I meant by "supervisor" is some (...) (23 years ago, 11-Apr-02, to lugnet.robotics.rcx.pbforth, lugnet.robotics.rcx)

9 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search