Subject:
|
Re: Firmware download troubles
|
Newsgroups:
|
lugnet.robotics.rcx
|
Date:
|
Fri, 13 Dec 2002 18:28:24 GMT
|
Viewed:
|
4275 times
|
| |
|
|
On Mon, 9 Dec 2002 20:49:25 GMT, "Matt White" <mwhite@silenus.com>
wrote:
> Hi All,
>
> I have pulled my RCX out of summer storage and I am trying to bring it to
> life. I have tried to download the 2.0 Firmware (firm0328.lgo) dozens of
> times with no success. It starts to download, then somewhere in the middle,
> or very close to the end (it varies), I get a "Firmware download failed. Put
> the RCX closer and try again." message. I am using the Bricx Command Center
> to do this.
>
> I can successfully dowload the "original" firmware that came with my set. I
> have RCX 1.0.
>
> I have replaced all the batteries - no change.
>
> Any help?
>
> Matt
It's funny that you should bring this up - I've had exactly the same
problems with several RCX's and downloading firmware from BrixCC.
The only solution I've been able to find is to download the firmware
using the RIS2.0 software and then return to BrixCC to do the
programming.
I'll be interested in what other solutions and, particularly,
explanations are put forward....
Incidentally, my downloads always fail at the "0008" point (as
displayed on the RCX). Thereafter, I can't download anything, from
either BrixCC or RIS2.0 until I turn the RCX off and on again. This
problem is annoying, but at least it's consistant.
Matthias Jetleb
|
|
Message is in Reply To:
 | | Firmware download troubles
|
| Hi All, I have pulled my RCX out of summer storage and I am trying to bring it to life. I have tried to download the 2.0 Firmware (firm0328.lgo) dozens of times with no success. It starts to download, then somewhere in the middle, or very close to (...) (22 years ago, 9-Dec-02, to lugnet.robotics.rcx)
|
10 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
